Oxford, UK, 4 June, 2015 – Desktop Engineering (DTE), a leading engineering software solutions provider, has supplied Avon Valley Precision Engineering (AVPE), a high quality precision-engineered component manufacturer for the Aerospace industry, with CATIA V5 Airbus Manufacturing and an ICAM CAM-POST NC post-processing solution to enable it to optimise the 3, 4 and 5-axis milling [...]
Do you know how to switch the feed rate mode from PERMIN to PERREV for Rigid Tapping? Rigid tapping cycles perform the following sequence of actions: the tool plunges at cutting feed, reverses the spindle, retracts at cutting feed and reverses the spindle again. If the CAM programmer uses proper best practices, whenever a tapping [...]
Rigid tapping cycles perform the following sequence of actions: the tool plunges at cutting feed, reverses the spindle, retracts at cutting feed and reverses the spindle again. If the CAM programmer uses proper best practices, whenever a tapping cycle is programmed, the feed rate should be expressed in units per revolution (PERREV). However, situations may [...]
Dedicated post-processors are delivered in an ICAM-proprietary file format, which is a binary file with a “.dp” extension. This file may contain one or more post-processors, Virtual Machine models and Control Emulators. For ease of use, ICAM recommends using the Import facility, available in the GENER launch panel, to read and import the contents of [...]
Modern machines use a function that changes the amount of acceleration / deceleration during synchronous tapping based on the current spindle speed and the programmed feedrate. The M-code required to activate this function can be generated by the post-processor using two simple user-defined macros on the major word CYCLE. The example below shows the technique [...]
On a lathe where X-axis values can be output either in diameter or radius mode, the following commands can make the switch possible. MODE/DIAMET: selects diameter output for the X-axis, if supported on the machine MODE/RADIUS: selects radius output for the X-axis, if supported on the machine The macro variable $XDIAM tracks the radius vs. [...]
The new interface is used to “extract” the necessary data from the Mastercam for Solidworks prior to launching the simulation process (either GENER for running a graphic post-processor, or CErun for G-code simulation). To setup CAM-POST to run within Mastercam for Solidworks, you must do the following: 1) Make sure Mastercam for Solidworks is installed [...]
A series of 99 $FINFO user-defined variables, from $INFO.V1 through $INFO.V99, are available for various purposes required by the developer. These variables are set to $NULL at the start of $FINFO look-ahead and can be assigned to any value (including a sequence), by macro processing while the $FNFO look-ahead is active. Once look-ahead is completed, [...]
CAM-POST provides a series of extractor interfaces seamlessly integrated within the following popular CAM systems: CATIA, NX-CAM, Creo-NC, Mastercam and TopSolid. These interfaces are used to “extract” the necessary data from the CAM system prior to launching the simulation process (either GENER for running a graphic post-processor, or CErun for G-code simulation). The new extractors [...]
